For
best results the surface
should always be pre-sealed with Rockstar
All Stone Pre-Seal before the surface
is cleaned and sealed.
Ensure the surface is free from grease
and dirt and that any prior coatings
have been removed. For heavily soiled
floors it is recommended that a combination
of Rockstar Heavy Duty Degreaser
(HDD) and Rockstar
Neutral Clean are used. Once
the floor is free from contamination
and dry, the sealing process can start.
Always test product
on a small area first. And
allow a 24-hour cure time to determine
the ease of application and desired
results.
Two coats of Rockstar Water-Based
Natural Finish Stone Sealer
should be applied with a low pressure
pump or a lambs wool applicator.
Allow 10 minutes for product to
penetrate surface then wipe the
surface with a clean white dry cloth
to remove excess product. The initial
coat coverage rate will vary between
5m2/lt (54ft2/qt) and 15m2/lt (161ft2/qt) depending on the porosity
of the material. Subsequent coats
will attain a coverage rate of up
to 20m2/lt (215ft2/qt). Allow drying time of around
60 minutes between coats depending
on weather and humidity. The surface
should be allowed 24 hours to fully
cure and develop weather resistance. |
