Quick links to products:
  

Natural Finish Stone Sealer
Download the MSD sheet for this product

Solvent based sealer designed to penetrate stone leaving a natural finish
Protects against graffiti, water and oil based contaminants while permitting vapour and salt transmissions
Suits concrete, limestone, sandstone, marbel and all other porous earthen materials
  Physical Properties
Colourless to yellowish haze
Mild solvent
PH n/a
Specific gravity 0.8
  Rockstar Natural Finish Stone Sealer is a state of the art solvent based sealer which is designed to penetrate the stone leaving it with a natural finish. Provides protection against graffiti and both water and oil based contaminants while permitting vapour and salt transmissions. Suitable for the use on concrete, limestone, sandstone, marble and all other porous earthen materials. All Rockstar penetrating products when applied according to the directions of the manufacturer, will protect against water damage and resist staining for 15 years.
  Application
 

For best results the surface should always be pre-sealed with Rockstar All Stone Pre-Seal before the surface is cleaned and sealed.

Ensure the surface is free from grease and dirt and that any prior coatings have been removed. For heavily soiled floors it is recommended that a combination of Rockstar Heavy Duty Degreaser (HDD) and Rockstar Neutral Clean are used. Once the floor is free from contamination and dry, the sealing process can start.

Always test product on a small area first. And allow a 24-hour cure time to determine the ease of application and desired results.

Two coats of Rockstar Natural Finish Stone Sealer should be applied with a low pressure pump (non electric) or a lambs wool applicator. Allow 10 minutes for product to penetrate surface then wipe with a clean white dry cloth to remove excess product. The initial coat coverage rate will vary between 5m2/lt (54ft2/qt) and 15m2/lt (161ft2/qt) depending on the porosity of the material. Subsequent coats will attain a coverage rate of up to 20m2/lt (215ft2/qt). There will be a drying time of around 60 minutes between coats depending on weather and humidity. The surface should be allowed 24 hours to fully cure and develop weather resistance.

  For Technical information regarding this product contact the Rockstar
  To view and print Waranty form, please click here.
  To view disclaimer,click here
   
Site last updated June 2009 | Site created by X2 Design