| Application
For best
results the surface should
always be pre-sealed with Rockstar
All Stone Pre-Seal before
the surface is cleaned and sealed.
Ensure the surface
is free from grease and dirt and
that any prior coatings have been
removed. For heavily soiled floors
it is recommended that a combination
of Rockstar Heavy Duty Degreaser
(HDD) and Rockstar
Neutral Clean are used.
Once the floor is free from contamination
and dry, the sealing process can
start.
Always test product
on a small area first. And allow
a 24-hour cure time to determine
the ease of application and desired
results.
Two coats of Rockstar
Concrete Seal should be
applied with a lambs wool applicator.
The initial coat coverage rate will
vary between 5m2/lt (54ft2/qt) and 20m2/lt (215ft2/qt) depending
on the porosity of the material.
Subsequent coats will attain a coverage
rate of up to 40m2/lt (430ft2/qt). There will be
a drying time of around 60 minutes
between coats depending on weather
and humidity. The surface should
be allowed 24 hours to fully cure
and develop weather resistance.
All tools can be washed out with
water. |